Zenmuse H3-3D Gimbal Bedienungsanleitung PDF herunterladen (Seite 16)

Appendix

Troubleshooting

Problem Cause Solution

Gimbal keeps drifting

after initialization.

1. The transmitter trims value is

beyond the acceptable limit.

2. The GCU is disconnected from the

ight control system.

3. The gimbal is not mounted correctly.

1. Adju

st the transmitter trims value.

2. Connect the GCU and ight control

system.

3. Ensure the gimbal is mounted so it

is parallel with the aircraft, and the

camera is

pointing towards the nose.

The gimbal axes are

not level.

Factory calibration error.

Contact your local dealer or DJI

customer service for assistance.

Unable to determine

gimbal orientation.

BVR (beyond visual range) ight.

Use a wireless video transmission

module.

Settings When Using the A2 Flight Control System

Users should congure the H3-3D’s pitch control in the A2 assistant when using the A2 Flight

Control System. Map the H3-3D to two channels on the transmitter as shown in the following

diagram. DJI recommends the use of a knob switch or a stick with spring back function for tilt

control, and a 2-position switch for MODE.

Zenmuse Channels

REV

Unmapped

ROLL

REV

PAN

REV

TILT

REV

MODE

REV

SHUT

REV

AUX1

REV

AUX2

REV

AUX3

Appendix

1 2 ... 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Zenmuse H3-3D Gimbal Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern