Zenmuse Z15 Betriebsanweisung PDF herunterladen (Seite 11)

CONNEX

User Guide

Air Unit (Transmitter)

Figure 2: Air Unit (Transmitter)

Table 1: Air Unit Components

S.BUS: Control port for the gimbal, which can be connected to a flight controller compatible

with the S.BUS protocol or directly to an Air Unit receiver for the purpose of controlling the

camera gimbal. S.BUS properties can be configured using the CONNEX Management

application, which runs on the computer connected to the Ground Unit, as described in

Chapter 4, CONNEXTM

Management Application on page 37.

Do not try to use the S.BUS signal for controlling the aircraft’s flight.

This port should only be connected to the gimbal’s S.BUS of D.BUS port.

Telemetry: Enables the display of flight control data from an aircraft that has a

MAVLink-supported flight controller overlaid on an On Screen Display (OSD). Telemetry

information includes flight mode, number of connected GPS satellites, speed, height and

more. To receive telemetry data on Ground Unit, the Air Unit should be connected to the

aircraft’s telemetry port. You may refer to Appendix B on page 48 for more information.

Power Connector: 8-26-VDC voltage (3−6 cells).

Micro USB Port: This port enables configuration and upgrade of the Air Unit software using

the CONNEX Management application, as described in Chapter 4, CONNEXTM

Management

Application section on page 37.

Mini HDMI IN: For receiving video from the camera.

HDMI Connector Screw: For stabilizing the HDMI cable to the Air Unit.

Link Button: The Air Unit is provided pre-paired (preregistered) with the Ground Unit that

comes in the box. The Link button can be used to pair up to three additional Ground Units

with the same Air Unit. You may refer to the Multicasting to Multiple Ground Units section on

page 34 for a description of how to pair additional Ground Units with an Air Unit.

Reset Button: Resets the Air Unit.

Tx Cable Antenna Ports: Two lightweight 2dbi cable antenna ports.

Reset Button

USB Port

HDMI IN Port

Two Tx Cable

Antenna Ports

Power

Link Button

LEDs

S-BUS Port

Telemetry Port

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Keine Kommentare

Zenmuse Z15 Betriebsanweisung Seite 11